Signal Conditioners

Signal Conditioners allow you to change the operation parameters of the ECU. There are two types:  EGO Sensor Conditioners and Frequency Calibrators and Clamps.

EGO Sensor Conditioner
The EGO Sensor Conditioner, (ESC1, ESC2-001 and ESC2-002) alters the signal from the EGO sensors under boost conditions. It may be used in either single or dual EGO sensor applications. There are 3 options.

ESC1 alters the signal from the EGO sensors under boost conditions. It may be used in either single or dual EGO sensor applications. Under vacuum conditions, it outputs a signal, which is identical to the EGO signals that appear at the input. Under boost, it outputs an internally generated signal to allow open loop operation.

The ESC2-001 is a Post Cat EGO Sensor Conditioner. 

The ESC2-001 is a Duel Post Cat EGO Sensor Conditioner.

Give us a call to order any of these products  (949) 521-4661
SS-ESC1
$219.00
SS-ESC2-001
$65.00
SS-ESC2-002
$85.00
Frequency Calibrator and Clamp
The Frequency Calibrator and Clamp (FCC1) is designed to condition the output of frequency based air flow meters.

The FCC1 is designed to be used on late model GM cars and Karman Vortex.  It is especially useful for re-calibrating modified engines. The alteration or addition of turbochargers, superchargers, fuel injectors or MAF sensors can alter air/fuel ratio. A secondary feature of the FCC1 is that it will clamp the output at a designated frequency. The FCC1 provides a way to set the air/fuel ratio for rich, lean or stoichiometric operation over the entire RPM and load range. The FCC1 is intended for use in kits for specific applications and may be ordered with fixed calibration. No user adjustment is provided.  
SS-FCC1
$208.00